Model Ship Builder :: Forums :: Build Logs :: POB Build Logs |
|
<< Previous thread | Next thread >> |
gunports |
Moderators: Winston, aew, bikepunk
|
Author | Post | ||
spider |
| ||
![]() Registered Member #1643 Joined: Sat Jun 11 2011, 01:38pmPosts: 7 | put the gunports in the other night, no doubt some of them dont line up properly, hey ho, am not after a job as master craftsman, and they will look ok once the rigging is finished!!!![]() ![]() ![]() ![]() | ||
Back to top | | ||
twintrow |
| ||
![]() Registered Member #121 Joined: Tue Jul 21 2009, 04:41amPosts: 436 | Spider if they are not reasonably in line you will have issues with your planking, 1st and 2nd layers. You may want to put down a temporary batten to check how far off they are, if any before planking. Just a suggestion to save your wits later. Tom | ||
Back to top | | ||
spider |
| ||
![]() Registered Member #1643 Joined: Sat Jun 11 2011, 01:38pmPosts: 7 | they're not a million miles awayif anything a few of them might be a mm or 2 out of line with the rest, i was just going to ease the planks around them, maybe letting a fraction out of a plank where the port is say a tad low, if any of them are seriously askew i would take them out and redo the slot in the frame to realign them. thanks for the suggestion though buddy | ||
Back to top | | ||
Powered by e107 Forum System