Forums / POB Build Logs / Sirene - 1775 French Frigate Corel kit 1:75 scale

Forums

Model Ship Builder :: Forums :: Build Logs :: POB Build Logs		<< Previous thread \| Next thread >>
Sirene - 1775 French Frigate Corel kit 1:75 scale

Go to page 1 2 3 4
Moderators: Winston, aew, bikepunk

Author

Post

daves

Sat Dec 17 2016, 02:40pm

Registered Member #105

Joined: Wed Jul 15 2009, 12:01pm
Posts: 2624

Vincent has a little more fine tuning of the hull before starting the planking. So I will go over to the general build logs and start a build topic on planking.

donfarr

Sat Dec 17 2016, 04:56pm

Registered Member #2001

Joined: Fri Dec 23 2011, 09:51pm
Posts: 1298

Hi Dave, Please try and cover the use of single plank using the fan, and using battens spileing, use of proportional diveders with or without the battens. THANKS AGAIN Don Farr

Roadking

Fri Dec 30 2016, 07:37pm

Registered Member #4869

Joined: Mon Dec 12 2016, 11:40pm
Posts: 15

I've been working on making the corrections that some have suggested. I used some wood filler and sanding to try to get the hull into the correct shape and smooth enough for the next layer.

I'm not sure the photos properly display how she looks because in some she looks like a pregnant whale, but that's not how it looks in reality.

As always, your feedback and comments are welcome. I'd like to know if I am ready to proceed based on the way it looks now, or if more work on the hull is needed to avoid disaster later.

Thank you,
Vincent

daves

Sat Dec 31 2016, 03:18pm

Registered Member #105

Joined: Wed Jul 15 2009, 12:01pm
Posts: 2624

it looks good, nice job of smoothing out the curves.

it could be just the angle or light but check the area by the blue arrows. There seems to be a little bump and dent when compared to the right side. Other than that your ready for planking.

if there is a bump don't be afraid to grind it out of there and patch it up

Roadking

Sat Dec 31 2016, 05:05pm

Registered Member #4869

Joined: Mon Dec 12 2016, 11:40pm
Posts: 15

Good catch. Thank you. That side does need a slight bit of filling and smoothing. I noticed a small area in at the bow as well.
Your help is always appreciated.

aew

Mon Jan 02 2017, 10:11am

aew

Registered Member #1929

Joined: Wed Nov 30 2011, 03:05pm
Posts: 2805

Might also be worthwhile having a look where the planking runs on to the stern post. it looks as though you have a step half way up where the first planking starts. Maybe you can thin those first few planks down towards the edge.

Roadking

Mon Jan 02 2017, 03:37pm

Registered Member #4869

Joined: Mon Dec 12 2016, 11:40pm
Posts: 15

Is this the area that you are referring to? I wasn't sure if that should be feathered into the keel or a step.

Roadking

Wed Jan 04 2017, 10:00pm

Registered Member #4869

Joined: Mon Dec 12 2016, 11:40pm
Posts: 15

Any ideas on how I can fix this?

As the plank runs around the front of the bow, it also has to lay flat onto the hull. Sort of a bend and twist.
I'm a bit stumped on this.
Any help is appreciated as always.
Thank you,
Vincent